Thingiverse
Bird Feeder
von gotling
16
Downloads
8
Likes
0
Makes
A bird feeder based on a PET juice bottle for holding seeds.
Improved design with higher borders from version of video.
Including Fusion 360 archive with three files:
1. Thread: Customise this one to a bottle of your choice.
2. Plate: Replace thread on this one if needed.
3. Roof: Goes on top of bottle so a hole can be made for refilling seeds.
Plate has a hole in the middle for screwing it into a stick that is put in the ground. Attach bottle with hole made in bottom. Fill up with seeds. Attach roof to protect from rain and snow.
YouTube short showing it in action: https://youtube.com/shorts/q6DSR2y1a7I?si=T4rqN4HUoFRWJooD
Improved design with higher borders from version of video.
Including Fusion 360 archive with three files:
1. Thread: Customise this one to a bottle of your choice.
2. Plate: Replace thread on this one if needed.
3. Roof: Goes on top of bottle so a hole can be made for refilling seeds.
Plate has a hole in the middle for screwing it into a stick that is put in the ground. Attach bottle with hole made in bottom. Fill up with seeds. Attach roof to protect from rain and snow.
YouTube short showing it in action: https://youtube.com/shorts/q6DSR2y1a7I?si=T4rqN4HUoFRWJooD
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
