Thingiverse
Bird spikes
door abial
4
Downloads
4
Likes
0
Makes
Spikes to mount on the roof or any other surface frequented by these flying rats ... erhm, pigeons.
Print one base and 3 spikes. Spikes should slide in the grooves in the base, use a drop of superglue to hold them together.
No supports needed, print from anything at any resolution ;) Not sure if PLA would withstand hot weather and other elements without wilting, so I used PETG.
Print one base and 3 spikes. Spikes should slide in the grooves in the base, use a drop of superglue to hold them together.
No supports needed, print from anything at any resolution ;) Not sure if PLA would withstand hot weather and other elements without wilting, so I used PETG.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!