Thingiverse
Bit Holder
von ipt
54
Downloads
33
Likes
1
Makes
Yet another bit holder.
It holds up to 10 Bits and a standard extension (10mm).
I printed the white part in TPU to hold the bits by friction,
other materials should work too.
For the orange part I used PLA. I tested it with 2.2 NM torque no Problem.
About 4.5 NM slightly deformed it but it didnt break.
Should be plenty for most parts.
It holds up to 10 Bits and a standard extension (10mm).
I printed the white part in TPU to hold the bits by friction,
other materials should work too.
For the orange part I used PLA. I tested it with 2.2 NM torque no Problem.
About 4.5 NM slightly deformed it but it didnt break.
Should be plenty for most parts.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!