Thingiverse
Bixler FPV Pod
von dermatin
6
Downloads
3
Likes
0
Makes
This is an FPV Pod i made for the Bixler 1.1, but it fits on all other Bixlers and Airplanes with similar-curved noses. Put some velcro on the nose and the pod and you can remove it and use on different planes.
It's made for a foxeer mini FPV cam and eachine 200mw VTX, but i guess every other mini-sized cam and every cheap VTX will fit in.
There are two versions of the nose mount. The steeper version goes more to the front and the curve of the nose, while the flat version is mounted further back. Whatever fits your airplane best!
All parts can be printed without support. Place them on standing on the flat front surfaces!
It's made for a foxeer mini FPV cam and eachine 200mw VTX, but i guess every other mini-sized cam and every cheap VTX will fit in.
There are two versions of the nose mount. The steeper version goes more to the front and the curve of the nose, while the flat version is mounted further back. Whatever fits your airplane best!
All parts can be printed without support. Place them on standing on the flat front surfaces!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
