Biyoo

One of the small people that live in my house and annoys me had seen a “Biyoo” (from Omniscient Readers Viewpoint) that sat on your shoulder like a parrot and wanted one for their cosplay. We came up with this after various iterations. It uses 2 10mm diameter by 3mm thick magnets in Biyoo’s base and 2 in the “Magnet Plate”. Plate goes inside of a jacket shoulder and snaps to Biyoo’s bum to hold her (it’s a “she” apparently) in place on the outside. The magnets are a push fit from my printer and didn’t need glue. If they are loose on your print they can be glued in. If they don’t fit, try scaling (for some reason “X-Y hole compensation” isn’t compatible with painted models) the whole model up by a fraction of a percent until they do. If doing this test using the “Magnet Plate” to save wasting filament. They need to be installed so that they snap together as shown in the pictures. The photo of Biyoo sat on the jacket shoulder is one of the previous iterations without the painted spiral o