BL Touch Mount for hypercube

I wanted to add the BL Touch to my printer since I wasn't having much luck with the proximity sensor, so the obvious choice was the BL Touch.
I wanted to get the sensor as close as I could to the print head and I didn't like the one created by BS3DP (no offense), so I found one listed by Chavostyle.
This one I liked, but it wasn't on the right side, so I flipped it and printed it.
It turned out the Touch's sensor fully retracted was still obstructing the print bed, so I had to alter it. So I imported the model into Fusion 360 and basically cloned it.
I have two versions, one is slightly shorter than the other (1mm)

I have uploaded the reversed one (put this off way to long, sorry)