Thingiverse
BL-Touch Sturdy mount 2mm higher
by sn9
1
Downloads
1
Likes
0
Makes
Remix of this bltouch mount : https://www.thingiverse.com/thing:4801856
This one is 2mm higher as the pin of the probe was touching the printed part sometimes.
Small extrusion where the endstop and the mount could touch.
And small extrusion around the hotend mount screws.
Works for me with a z offset of -0.80mm.
This one is 2mm higher as the pin of the probe was touching the printed part sometimes.
Small extrusion where the endstop and the mount could touch.
And small extrusion around the hotend mount screws.
Works for me with a z offset of -0.80mm.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
