Thingiverse
Black Widow Corner Bracket
von MODesign
29
Downloads
18
Likes
0
Makes
My own take on a corner bracket design, I'm a fan of "nuts and bolts" look so designed it with a specific look in mind.
Required: 15mm low profile M5 screws + T nuts
Keep in mind, each bracket takes 5 screws, 3 for the vertical beam, 2 for the horizontal one, 8 brackets will require 40 screws/nuts.
Very solid and sturdy, small riblets connect every pressure point, at 15% infill it was already very hard to cause any deflection.
Required: 15mm low profile M5 screws + T nuts
Keep in mind, each bracket takes 5 screws, 3 for the vertical beam, 2 for the horizontal one, 8 brackets will require 40 screws/nuts.
Very solid and sturdy, small riblets connect every pressure point, at 15% infill it was already very hard to cause any deflection.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!