Thingiverse
BlackBerry Z10 Case
por kingtut
19
Descargas
16
Likes
3
Makes
Basic case with cross-hatch pattern on back for BlackBerry Z10.
Note that the case is quite tight, so you may wish to add a mm on length/width. I successfully printed with PLA on my Ultimaker, however I recommend using a soft/flexible plastic - getting the phone in/out of the case without cracking isn't always trivial. The case is sensitive to warping at corners, as the tolerances are rather tight.
If you want to change the pattern, I recommend making the change in the pattern() module.
No liability accepted for any damage to your phone.
Note that the case is quite tight, so you may wish to add a mm on length/width. I successfully printed with PLA on my Ultimaker, however I recommend using a soft/flexible plastic - getting the phone in/out of the case without cracking isn't always trivial. The case is sensitive to warping at corners, as the tolerances are rather tight.
If you want to change the pattern, I recommend making the change in the pattern() module.
No liability accepted for any damage to your phone.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!