Thingiverse
Blackhawk Lowboy 3 Switch Mount
von doenute
2
Downloads
3
Likes
0
Makes
This 3D print is useful for relocating the run/start switch on the Aero 1000 engine powering a Lowboy 3 quad powered Paraglider.
Additional parts required are:
2 pieces M4 X 25mm SHCS
2 pieces M4 X 40mm SHCS
4 pieces Heat set inserts: McMaster-Carr 94180A353
The heat set inserts are applied with a soldering iron into pockets on the back of the clamp to receive the cap screws.
Additional parts required are:
2 pieces M4 X 25mm SHCS
2 pieces M4 X 40mm SHCS
4 pieces Heat set inserts: McMaster-Carr 94180A353
The heat set inserts are applied with a soldering iron into pockets on the back of the clamp to receive the cap screws.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!