Thingiverse
BlackIce Board Case
von anthonysavatar
4
Downloads
5
Likes
1
Makes
A simple case for the [BlackIce board](https://nanode0000.wordpress.com/2017/08/16/getting-started-with-mystorm-blackice/) ([Forum](https://forum.mystorm.uk/) / [Buying info](https://forum.mystorm.uk/t/more-blackice-boards-available/202/4)).
The lid hinge is held in place using a straitened paperclip 1mm in diameter.
Printed on a Prusa i3 MK2S in PLA with .2mm layer height.
`blackice_top_half.stl` needs to be printed with supports.
Here are the [recommended screws](https://www.amazon.com/gp/product/B00GDXU4WM). You will also want some sticky rubber feet to keep it from sliding around.
Design files: [Fusion 360](http://a360.co/2x9EajF)
The lid hinge is held in place using a straitened paperclip 1mm in diameter.
Printed on a Prusa i3 MK2S in PLA with .2mm layer height.
`blackice_top_half.stl` needs to be printed with supports.
Here are the [recommended screws](https://www.amazon.com/gp/product/B00GDXU4WM). You will also want some sticky rubber feet to keep it from sliding around.
Design files: [Fusion 360](http://a360.co/2x9EajF)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!