Thingiverse
Blackice MX Case
by alejomejia1
1
Downloads
0
Likes
0
Makes
A simple and small case for the BlackIce MX board.
Printed on a Ender 3 PLA with .2mm layer height.
No need supports.
No need screws
Top part must be rotated 180 degrees to print over flat area.
OpenSCAD file V2 include basic parametric design, better comments and access for microSD card from outside. Change some names in order to use one single language. Improvements in top part
Thank you for your valuable comments and contributions.
Davidp . Thank you for your valuable comments and contributions.
Printed on a Ender 3 PLA with .2mm layer height.
No need supports.
No need screws
Top part must be rotated 180 degrees to print over flat area.
OpenSCAD file V2 include basic parametric design, better comments and access for microSD card from outside. Change some names in order to use one single language. Improvements in top part
Thank you for your valuable comments and contributions.
Davidp . Thank you for your valuable comments and contributions.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!