Thingiverse
Blackmagic Micro Converter LP-E6 Adapter
by AshTheMaker
53
Downloads
37
Likes
0
Makes
Model
These adapters allow you to attach a Blackmagic Micro SDI -> Hdmi converter to the SmallHD501 but the adapters should work on other monitors with LP-E6 battery slots.
Print Settings
I would highly recommend printing this with 3+ walls and a strong, stiff filament like PLA, Nylon or PETG.
Parts needed
2 x m3 8mm countersunk screws
1 x 5 - 30cm Hdmi to Hdmi Cable
Installation
(1) Remove the two M3 Phillps screws from either the right or left side
(2) Attach the adapter as shown above in the pictures
(3) Screw in the bracket using longer (6mm - 8mm) M3 countersunk screws to attach the bracket
Disclaimer
Adding this adapter and removing the two screws should not void your warranty, only removing the two screws will still keep the metal cover attached so there is no risk of damaging the converter. (Using screws that are too long will collide with the hdmi and sdi ports, if you tighten them hard enough you can possibly damage the converter)
Website
These adapters allow you to attach a Blackmagic Micro SDI -> Hdmi converter to the SmallHD501 but the adapters should work on other monitors with LP-E6 battery slots.
Print Settings
I would highly recommend printing this with 3+ walls and a strong, stiff filament like PLA, Nylon or PETG.
Parts needed
2 x m3 8mm countersunk screws
1 x 5 - 30cm Hdmi to Hdmi Cable
Installation
(1) Remove the two M3 Phillps screws from either the right or left side
(2) Attach the adapter as shown above in the pictures
(3) Screw in the bracket using longer (6mm - 8mm) M3 countersunk screws to attach the bracket
Disclaimer
Adding this adapter and removing the two screws should not void your warranty, only removing the two screws will still keep the metal cover attached so there is no risk of damaging the converter. (Using screws that are too long will collide with the hdmi and sdi ports, if you tighten them hard enough you can possibly damage the converter)
Website
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
