Blackstone Griddle Replacement Knob

This knob should fit all sizes of Blackstone Griddles. My buddy had a Blackstone Adventure 17 griddle given to him, I had one, so pulled the knob off and measured it up with calipers and a depth gauge so I could print him one. I printed it out of PETG and also one out of Easy ABS, either should be sufficient to handle any heat the handle gets and I don't think it's much since the original is also plastic. PLA will deform from the heat on the shaft that the knob attaches to. If you've not used Easy ABS, it's great. I select PLA in the profile, no smell, no need for an enclosure, not quite true ABS from temperature perspective, but very resistant to chemicals, etc. having many of the other characteristics of ABS and still a good temperature tolerance as shown below. PLA will begin to soften at 60-65C (140-145F)PETG can withstand 80-85C (176-185F) before it starts to soften.Easy ABS can withstand 99C (210F) before it starts to soften.There is a hole for a M3x25 barrel hex