Thingiverse
bladeRF 2.0 micro case
von roach118
12
Downloads
12
Likes
1
Makes
A case for the bladeRF 2.0 micro.
The PCB mounts are 1.9mm holes so they can be tapped with an M2 tap or a self tapping screw. You can also print the mounting pins, however be careful when pressing into the hole as they will snap easily.
printed with generic PLA and no supports.
The version in the photos was the second iteration while the scad/stl files are the third iteration. The PCB mounts and USB/power holes were moved slightly.
The PCB mounts are 1.9mm holes so they can be tapped with an M2 tap or a self tapping screw. You can also print the mounting pins, however be careful when pressing into the hole as they will snap easily.
printed with generic PLA and no supports.
The version in the photos was the second iteration while the scad/stl files are the third iteration. The PCB mounts and USB/power holes were moved slightly.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
