Thingiverse
Blinds turning knob
por usable_3d
4
Descargas
3
Likes
0
Makes
So i had a turning knob break off so i made a replacement part
My printer is pretty bad so i tried to make it pretty easy to print (flat bottom surface) and used a large adhesion brim to get it to print. Turned out better then the old yellow one :)
Use Concentric setting for bottom layers (looks better)
Clear off old material from the old rod and put this new one on with a drop of glue. With my settings it stays on even without glue (rod 3,85mm - hole in part is 4mm)
My printer is pretty bad so i tried to make it pretty easy to print (flat bottom surface) and used a large adhesion brim to get it to print. Turned out better then the old yellow one :)
Use Concentric setting for bottom layers (looks better)
Clear off old material from the old rod and put this new one on with a drop of glue. With my settings it stays on even without glue (rod 3,85mm - hole in part is 4mm)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!