Blink Ball

Like others I found that the Blink Ball was inserted very firmly and felt that I couldn't remove it without breaking something so I went into Fusion 360 and designed my own. While there was one version already on Makerworld, I couldn't use it because it didn't allow for the reset button in the bottom of the blink. My version has a hollowed section to allow for this.This can be printed without supports. I printed it both with and without however on both my A1 and A1-Mini it prints fine without supports. To assemble, pull the Blink off the support it comes with. Then push in this adapter, tolerances are relatively tight so you may have to wiggle it a bit, I found it best to insert one clip, then push down on the other. Inserting the Ball into EITHER the A1 or A1 Adapter (available on Makerworld) is pretty simple. I then routed the power cable for the Blink and zip tied it to the main power cable on my printer. I also zip tied it to the bracket which helps to hold it in place.