Slicer Discord
Blink Doorbell wall installation panel – 3D-printbaar model van Thingiverse Thingiverse

Blink Doorbell wall installation panel

door Elsni
0 Downloads
5 Likes
0 Makes
Model downloaden
## Blink Video Doorbell wall installation panel

If an old intercom system is to be replaced by the Blink Doorbell, the existing wall opening can be used to accommodate the Blink Doorbell so that it does not protrude as it would otherwise, and it also provides protection against the weather and theft.

The panel consists of three parts that are inserted into each other, otherwise it would be too large for most printers.
The Blink fits tightly in the holder.

## Blende für Wandeinbau einer Blink Video Doorbell

Wenn eine alte Gegensprechanlage durch die Blink Doorbell ersetzt werden soll, kann man die vorhandene Wandöffnung gut als Aufnahme für die Blink Doorbell verwenden, so dass diese nicht wie sonst hervorsteht.
Zugleich ist es ein Wetter- und Diebstahlsschutz.
Die Blende besteht aus drei Teilen die ineinandergesteckt werden, damit das Ganze aufs Druckbett passt.
Die Kamera passt stramm in die Halterung.
Bron
Thingiverse
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

Elsni publiceert ook op

15 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie