Thingiverse
Blink XT Camera Mounts
von tmarks11
1
Downloads
2
Likes
0
Makes
Camera mounts which screw flat against a surface. 4 versions... camera flat, camera angled right by 10 degrees, camera angled up by 10 degrees, camera angled up by 20 degrees.
Will require rotating to put the bottom of the mount against the print bed. No supports needed.
Will require rotating to put the bottom of the mount against the print bed. No supports needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!