Thingiverse
Block'n'Tackle
von CrunchWorks
58
Downloads
46
Likes
0
Makes
Ladies and Gentleman!
What we have today is fantastic! Extraordinary! Mind-blowing.....
This kit will salve all of your problems.
The pulley system is designed for ~4mm paracord.
It requires (4) 608 ball bearings (I got 100 for $17USD).
The wall mounted pulley is sized for wood screws, I use DeckMates.
M6 screws will "self-Tap" into the hole on the bottom of the block.
Its a tight fit, but the bearings will press in. I use a block of wood and a mallet.
What we have today is fantastic! Extraordinary! Mind-blowing.....
This kit will salve all of your problems.
The pulley system is designed for ~4mm paracord.
It requires (4) 608 ball bearings (I got 100 for $17USD).
The wall mounted pulley is sized for wood screws, I use DeckMates.
M6 screws will "self-Tap" into the hole on the bottom of the block.
Its a tight fit, but the bearings will press in. I use a block of wood and a mallet.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!