Thingiverse
Blocks for displaying CD
von asimomagic
3
Downloads
5
Likes
0
Makes
These are blocks for displaying CD.
By using this, you can easily fix the CD on the board.
[design]
There are 4 types of lower blocks and 1 type of upper block.
The block size is W36xD36xH26mm. (lower + upper)
The CD is fixed about 10 mm above the board.
A 10mm circular dent is made to make it easier to apply the cushioning material for suppressing rattling.
[how to use]
-print the necessary blocks.
-apply cushioning material to the blocks.
-check the tightness of the screw holes in the blocks with M4 bolts. If you feel a little tight, try tapping.
-make holes (4mm + α) to fix the lower blocks to a plate.
-fix the lower blocks with M4 bolts or tapping screws. The recommended length of the bolt is about (plate thickness + 8 mm).
-set the CDs.
-fix the upper blocks with M4 CAP bolts. Recommended length is 10mm.
By using this, you can easily fix the CD on the board.
[design]
There are 4 types of lower blocks and 1 type of upper block.
The block size is W36xD36xH26mm. (lower + upper)
The CD is fixed about 10 mm above the board.
A 10mm circular dent is made to make it easier to apply the cushioning material for suppressing rattling.
[how to use]
-print the necessary blocks.
-apply cushioning material to the blocks.
-check the tightness of the screw holes in the blocks with M4 bolts. If you feel a little tight, try tapping.
-make holes (4mm + α) to fix the lower blocks to a plate.
-fix the lower blocks with M4 bolts or tapping screws. The recommended length of the bolt is about (plate thickness + 8 mm).
-set the CDs.
-fix the upper blocks with M4 CAP bolts. Recommended length is 10mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!