Thingiverse
BLTouch/3DTouch Sensor Holder
von s_s_
9
Downloads
4
Likes
0
Makes
This is a thing i made, that is compatible for Thing #992952 (https://www.thingiverse.com/thing:992952) and a volcano hotend.
It is a BLTouch/3DTouch Holder, that works well on my configuration.
In my Settings i use a Z Offset of -0.9mm, but yours might differ.
It is a BLTouch/3DTouch Holder, that works well on my configuration.
In my Settings i use a Z Offset of -0.9mm, but yours might differ.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
