Thingiverse
BLTouch Cover
by Csewell
78
Downloads
39
Likes
3
Makes
A very simple BLTouch cover. This blocks the light from the sides and the bottom, while being secured by friction. I left a small opening in the front so I can see the LED while it's doing its leveling, as my webcam is to the side.
Print standing up and then slide on from the bottom, making sure to press all the way up. This is a snug fit, but not so snug that you should have any tolerance issues.
There's also an STL for a print without the opening for the LED on the front in case your webcam points directly at the BLTouch
Print standing up and then slide on from the bottom, making sure to press all the way up. This is a snug fit, but not so snug that you should have any tolerance issues.
There's also an STL for a print without the opening for the LED on the front in case your webcam points directly at the BLTouch
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
