BLTouch Fixed Position Mount for Makerfarm i3v

This is a fixed mount for the BL Touch (tested with v3.1) used as a drop in replacement for the Makerfarm i3v 8, 10, 12" printers. It is a replacement for the wooden part on the left side of the extruder idler and can replace this great ABL servo mount from clough42. I'm using a hexagon hot end so the fixed position is perfect for my setup but may need to be adjusted for your build, please feel free to update the included .STEP file. The mounting holes are spec for two M3x10 screws.

Assuming you have the original RAMPS 1.4 board (other boards may need different wiring), all you need to do converting this from a servo probe microswitch is to connect is to the same pins as the ABL servo and microswitch and change the probe offset values from the nozzle in marlin (which will be specific to your printer) and update the servo angles in marlin to agree with the bltouch extend and bltouch stow commands associated with angles 10 and 90 respectively.

See example below:

Servo probe vers