Thingiverse
BLTouch mount / Chain connector for E3V2
von LennDog
17
Downloads
7
Likes
0
Makes
This is a remix of the BLTouch and the Drag Chain x-axis mounts for Creality Ender 3 V2, see credits below.
This remix was created due to the need to use both the BLTouch and a cable chain, as the original parts do not fit together.
Both parts are secured to the extruder metal plate the same way as the original BLTouch mount. The cable mount has had the roller wheel slots removed for ease of install, the single bolt provides sufficient mounting strength.
------------------------------------------------------------------------------------------------------------------------
For an accurate fitment:
Use a spirit level to make sure that the part is perfectly aligned and parallel to the x-axis rail.
Tighten the nut behind the travel wheel, rather than turning the bolt with the allen key. Thus the part won't move because the bolt won't be turned.
BLTouch offset:
X-42.00 Y-10.00
----------------------------------------------------------------------------------------
This remix was created due to the need to use both the BLTouch and a cable chain, as the original parts do not fit together.
Both parts are secured to the extruder metal plate the same way as the original BLTouch mount. The cable mount has had the roller wheel slots removed for ease of install, the single bolt provides sufficient mounting strength.
------------------------------------------------------------------------------------------------------------------------
For an accurate fitment:
Use a spirit level to make sure that the part is perfectly aligned and parallel to the x-axis rail.
Tighten the nut behind the travel wheel, rather than turning the bolt with the allen key. Thus the part won't move because the bolt won't be turned.
BLTouch offset:
X-42.00 Y-10.00
----------------------------------------------------------------------------------------
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
