Thingiverse
BLtouch mount for DBot CoreXY
von robohead456
83
Downloads
42
Likes
0
Makes
This is a remixed design of axelsp's D-Bot Hotend clamp with BLTouch mount.
It was modified to hold the BLTouch in front of the extruder, which makes room for fans on the side of the extruder and also brings the sensor closer to the nozzle.
To mount the BLTouch I recommend putting a M3 washer between the printed part and the sensor. To finely adjust the spacing between the nozzle and the bed, tighten the bolts. This forces the washer to deform the printed piece slightly.
It was modified to hold the BLTouch in front of the extruder, which makes room for fans on the side of the extruder and also brings the sensor closer to the nozzle.
To mount the BLTouch I recommend putting a M3 washer between the printed part and the sensor. To finely adjust the spacing between the nozzle and the bed, tighten the bolts. This forces the washer to deform the printed piece slightly.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
