Thingiverse
BLTouch test checkers field
por Kir3D
22
Descargas
16
Likes
0
Makes
[ If you like my model(s), please visit this page https://www.facebook.com/neorisKir/ and set "Like" to it! you will help me more than even giving a tip. Thanks in advance! ]
It's a good measure to check if your BLTouch is working evenly over the whole bed.
Designed for Tevo Flash. Will be good for Ender-3 as well!
The squares are connected but just slightly.
Print on a clean surface, use a hair spray or a 3d-laque to make a good adhesion (if you have a glass or a mirror). Printing on a painter's tape is possible but not the ideal option. Use an appropriate glue then.
This test uses a relatively small amount of a filament. It will be printing for about 30-40 minutes but shows any issues clearly.
It's a good measure to check if your BLTouch is working evenly over the whole bed.
Designed for Tevo Flash. Will be good for Ender-3 as well!
The squares are connected but just slightly.
Print on a clean surface, use a hair spray or a 3d-laque to make a good adhesion (if you have a glass or a mirror). Printing on a painter's tape is possible but not the ideal option. Use an appropriate glue then.
This test uses a relatively small amount of a filament. It will be printing for about 30-40 minutes but shows any issues clearly.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!