Blue Roll Holder

Blue roll holder. This is a holder for standard sizes of blue roll.up to 200mm width and up to 230mm diameter.bore size of 60mm standard. if your blue roll is larger bore it will still work fine. prints in one plate including the centre holders.print with supports enabled.the cube shapes on the build plate are modifiers and must stay where they are, these are to take the infill up to 20% around the fixing points for strength.the rest of the model is printed at 5% honeycomb infill to keep it at just over 400g, not bad for a print taking up almost all the build room available! the rear cross sections are flimsy but theyre just a guide to keep it spaced apart when screwing it to a surface.mark the holes, screw screws in and slot the holder over then tighten screws.pop the centre cylinders into blue roll then drop into the holder. depending on width of blue roll you may need to pull the cylinders outwards a bit untill they fit nice and smooth in the frame.Boost MeIf you're downloading