Thingiverse
bluer filament guide
von florianlesueur
9
Downloads
6
Likes
0
Makes
Designed this part for my bluer. Made to recieve the end filament detector.
Use 1 Skateboard bearing Ø22, 6 washers Ø8, a screw and its nut M8.
Hope you'll like the silence created by the bearing.
Use 1 Skateboard bearing Ø22, 6 washers Ø8, a screw and its nut M8.
Hope you'll like the silence created by the bearing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
