Thingiverse
Bluer_filament_guide
von MR3D_ca
3
Downloads
2
Likes
0
Makes
A remake of thingiverse made for Biqu B1 https://www.thingiverse.com/thing:4778794, but made for the Bluer. Not the best looking design, but it works good. Here are the improvments: So on the original made for the bearings and screw needs.
- Works for Bluer TwoTrees !
- Helps to hold the wirring
- Added a "stopper" so if you move the head going up the filament will not get outside the roller.
- Added a little visual help on the roller to help see the movement of the roller.
- Works for Bluer TwoTrees !
- Helps to hold the wirring
- Added a "stopper" so if you move the head going up the filament will not get outside the roller.
- Added a little visual help on the roller to help see the movement of the roller.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
