Slicer Discord
Bluetooth Boom Box – 3D-printbaar model van MakerWorld MakerWorld
Electronics

Bluetooth Boom Box

15 Downloads
9 Likes
2 Makes
Model downloaden
This boom box is centered around two 3 inch (77mm) 4ohm 20 watt speakers and a readily available Bluetooth amplifier board that features bass and treble control. Honestly don't bother with the tweeters, I didn't notice a difference and sourcing a standard pair is a bit difficult. Just print the plugs and glue them in. Power! Ok this amp has minimum voltage of 12v and can go up to 24v, you can over power the speaker easily. Figure what wattage you need and choose a power supply that works for you. With the speakers listed below you will want something that can run 40 watts at a minimum, I linked a 12v 5amp which is more than needed at 60 watts. Be warned, its loud Here are the parts I used on my build:https://amzn.to/47Hlz1v Amp board with bluetoothhttps://amzn.to/4oDx1kB 3 inch 4ohm 20w 2packhttps://amzn.to/49gURhp Stainless steel metric button head hardware kithttps://amzn.to/49PX57C knurled thread insert nut kithttps://amzn.to/449DT0Q DC Power Jack Socket 5.5 x 2.5https://amz
Categorie
Electronics
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Waarom?
uitgebreide nabewerking
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 2/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
Nabewerking
Lijmen, Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie