Thingiverse
Blum TANDEMBOX
von Zilvervos
1
Downloads
1
Likes
0
Makes
This is a replacement part for Blum TANDEMBOX (soft close).
I used a shaft 14mm long and 3mm in diameter.
(A piece of an old 3mm drill bit.)
The shaft is fixed in the part with a drop of superglue.
To do this, use the tool (while gluing) so that the shaft sticks out exactly 1.5 mm.
Clean and degrease the existing parts.
Lubricate the guide with silicone spray, The new part and the (existing ) rubber part, you lubricate by spraying a little silicone spray in a tissue and then very lightly lubricate the new part and the existing rubber part.
I used a shaft 14mm long and 3mm in diameter.
(A piece of an old 3mm drill bit.)
The shaft is fixed in the part with a drop of superglue.
To do this, use the tool (while gluing) so that the shaft sticks out exactly 1.5 mm.
Clean and degrease the existing parts.
Lubricate the guide with silicone spray, The new part and the (existing ) rubber part, you lubricate by spraying a little silicone spray in a tissue and then very lightly lubricate the new part and the existing rubber part.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
