BLV AMS Riser LED button holder

This is printed holder for a small button to allow you to turn on/off an LED strip (or anything else) that's plugged into the built-in USB port on a Bambu P1S. The main benefit to this one is you don't have to reprint any pieces of the Riser, except for the little hole cover. This is about a 5-minute print. The button is friction-fit. If you have an LED strip that's plugged into the USB port in the printer, you can just pull some of the spare length of cable up through the existing hole in the BLV riser, and then solder the button to the wires. This frame holds the button in place once you push the wires back down. I used these buttons because they're very small and can fit into the existing plug without reprinting any major pieces of the riser, including the faceplate or underpieces. https://a.co/d/dYuImLk Feel free to ask me questions. Enjoy!