Slicer Discord
BM5150 Vtech Parent unit Wall mount – Modelo 3D imprimible de MakerWorld MakerWorld
Gadgets

BM5150 Vtech Parent unit Wall mount

25 Descargas
8 Likes
13 Makes
Ver Modelo
This model is for an easy print to mount up the BM5150 or similar Vtech 5" parent units to the wall. While rough around the edges due to minimal refinement it does the intended job fine. Prints on untuned machines reasonably well and in my case only needed a light sand and spray paint in order to suit the unit and location it was going.I use 8g x 16mm multipurpose screws to mount this as they're very cheap at Bunnings. I also added to 3mm rubber circles the sticky bumper kind to the back to slightly change the viewing angle and stop the monitor from being able to slide at all. Please feel free to refine or remix as you see fit, just add remix files to the remix tab cheers.
Categoría
Gadgets
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Intermedio Baja confianza
¿Por qué?
sin soportes · postproceso considerable
Sin soportes Pieza única Tornillería requerida
Soportes 0/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 3/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Postprocesado
Pintura, Lijado, Tornillería
Software
Cura, PrusaSlicer o similar
Mismo diseñador, más plataformas

Khalm Down Hobbies también publica en

32 modelos adicionales en 2 plataformas más

Verificado por coincidencia de títulos de modelos entre plataformas.
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

1 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección