BMG Wind Mount KP3s

Used this as base, therefore labeled it as a remix: https://www.thingiverse.com/thing:4613228

Only requires a BMG Wind 24V LEFT version (probably works if you mirror it for a right one). Works with the stock stepper, and you don't need additional screws for the mount itself. Stopend (for X zeroing) may need some scaling. It goes in the backside hole.

Print without support in the backside hole but with support for the hole.

Loses 1.5cm on X axis and 1.2 on y axis Z axis. When I get a smaller stepper I will fix it for it, and will probably regain those 1.5cm.

Current version is printed on ERYONE Red PETG. When I have this finished I will probably print it in ABS, as I intent to enclose it (with the Lack enclosure).


P.d.: Benchy picture is without any tweaking at all over my old cura settigns other than extruder steps. Also printed with the previous version of this mod.

P.d.2: The fan for the bmg wind is another remix you can find in my profile!