Thingiverse
BMW E9x E6x Speaker Adapter
von Arias97
15
Downloads
14
Likes
0
Makes
20. November 2022
So i remixed this Speaker adapter with larger opening. I marked holes with speakers and drill them. I used Crucnh DSX 42 Coaxes and the opening is a little bit larger.
NEW !!! - Added holes for M5 screws and to use the low profile NUTS behind. I always solder the speaker wire to the speaker and protect with heatshrink. I also go for a connector on this wire to easy disasseble all of it. Then i mount it to the adapter.
Use 100% infill, especcially with PETG. Suitable for ABS, ASA and PETG. Sometimes i also used GF ABS, its ok but little brittle.
So i remixed this Speaker adapter with larger opening. I marked holes with speakers and drill them. I used Crucnh DSX 42 Coaxes and the opening is a little bit larger.
NEW !!! - Added holes for M5 screws and to use the low profile NUTS behind. I always solder the speaker wire to the speaker and protect with heatshrink. I also go for a connector on this wire to easy disasseble all of it. Then i mount it to the adapter.
Use 100% infill, especcially with PETG. Suitable for ABS, ASA and PETG. Sometimes i also used GF ABS, its ok but little brittle.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!