Thingiverse
BNC Housing
von BP_685
8
Downloads
3
Likes
0
Makes
Housing designed to connect a BNC to wire.
1) Run wire through body from outside to inside.
2) Tie a knot in wire or use a cable tie as strain relief.
3) Tighten BNC onto cap.
4) Make solder connections.
5) Use glue on inside of body where cap will fit.
6) Pull wire out to till it stops.
7) Press cap into place.
8) Let dry.
1) Run wire through body from outside to inside.
2) Tie a knot in wire or use a cable tie as strain relief.
3) Tighten BNC onto cap.
4) Make solder connections.
5) Use glue on inside of body where cap will fit.
6) Pull wire out to till it stops.
7) Press cap into place.
8) Let dry.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!