Thingiverse
Board Game Spinner Arrow
by MRKPMNTL
78
Downloads
70
Likes
1
Makes
Needed a board game spinner replacement. At 100% this clocks in just over 8cm / 85mm which is perfect for the Peppa Pig Chutes and Ladders game I needed it for. Its not too flimsy for toddlers and little ones and doesnt have any sharp/pointy edges.
Printed using PLA on low quality settings in Cura.
Layer Height: 0.28mm
Infill Density: 20%
Infill Type: Cubic
Took about 18 minutes based on my settings and printer.
Printed using PLA on low quality settings in Cura.
Layer Height: 0.28mm
Infill Density: 20%
Infill Type: Cubic
Took about 18 minutes based on my settings and printer.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
