Slicer Discord
Boat Flag Mount – 3D-printbaar model van MakerWorld MakerWorld
Sport & Outdoors

Boat Flag Mount

42 Downloads
25 Likes
16 Makes
Model downloaden
Have a couple of flags that I want to hang from the 1" posts on the bimini top on my boat. Printed in PETG (blue). It is just a smidge bigger inner diameter than 1" so there is a screw to snug it down. Note that the threads on the screw are fine so that it holds, but also makes it a pain to get them started. If you find they are too snug, which can be due to printer, filament, etc. you can size them up or down accordingly in the slicer. You could also use a couple wraps of grip tape and clamp over it if you don't want to use the screws. These clamps aren't really meant to be put on, taken off, put on, taken off, though they will come off easily enough if you need to remove them.IMPORTANT: If you have a FAST boat, I highly recommend you use an actual carabiner between the mount and the flag. The included printable version is strong, but I doubt it's strong enough for a fast boat across the water. Your call, you've been warned! :) Boost MeIf you like this model, p
Categorie
Sport & Outdoors
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PETG
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie