Boat Transom Bilge Mount

Updated versions of my original bilge discharge mount. The original design, I messed up and the hole to mount the discharge plate (or whatever its called) was too big, so I shrunk it down. Also the space for the mount to slide over the transom was too small by about 1 16th of an inch, so i widened that a little bit.

version 3 is pretty much the same as version 2 however instead of sliding it over the transom, it must be screwed into the transom. I came up with this because when I went to put the original version on and it was too small I decided to snap off the outside wall and just screw it in using the one side on the inside of the transom. It worked good on the test run. I would have like it to be a little stronger because I did end up snapping the mount while working on the boat, however, with regular use it is plenty strong