Cults3D
€ Paid
Game
Go to Model
Bob-omb Deck Box
0
Downloads
0
Likes
0
Makes
In the suggestion channel in my Discord https://discord.gg/ue3QNyjdZW, there were a good amount of suggestions for Mario themed Deck boxes. I was feeling inspired and this is what popped out.
This prints without supports. It does require multicolor printing for the bomb piece with the shoes. That part took 4 hours on my Snapmaker U1. I've attached a screen shot of how long it will take on a Bambu Lab P1S.
The Key, Eyes, and Fuse all require glue.
Use up to 8-8mmx2mm Magnets. CA Glue to adhere them to the box.
Magnet strength-
I use these magnets from Bambu. I have tried ones off amazon and its hard to figure out what the strength is going to be these bambu magnets work well for me.
https://us.store.bambulab.com/products/round-magnet?id=42424856477832
This prints without supports. It does require multicolor printing for the bomb piece with the shoes. That part took 4 hours on my Snapmaker U1. I've attached a screen shot of how long it will take on a Bambu Lab P1S.
The Key, Eyes, and Fuse all require glue.
Use up to 8-8mmx2mm Magnets. CA Glue to adhere them to the box.
Magnet strength-
I use these magnets from Bambu. I have tried ones off amazon and its hard to figure out what the strength is going to be these bambu magnets work well for me.
https://us.store.bambulab.com/products/round-magnet?id=42424856477832
thatcaddad also publishes on
118 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
