Thingiverse
Bodum Coffee Filter Holder
door MrDJMedina
10
Downloads
8
Likes
0
Makes
My First Design Upload.
After buying my Bodum pour over coffee maker, I needed a way to set the used coffee filter down without tipping it over and spilling hot grounds all over the place.
So I designed this.
Even after one print I redesigned it from the ground up and I am so happy with the new design.
It prints in 4 parts. The base and ring measure in at 140mm. I also put in the file with and without the caffeine molecule so if you wanted to remix and add your own logo you could.
All parts should snap together no glue needed (at least with my prints).
** also I dont know how to put the legs on the print floor from the model so you may have to re-orient the legs to the print bed. Make sure the chamfer side is up.
** also all the legs are the same. You can grab one and duplicate or bring all 3 to your slicer.
Print times:
Ring and legs = 1hr 7 mins
Base w/ Molecule = 2 hr 47 mins
Base w/o Molecule = 1 hr 50 mins
After buying my Bodum pour over coffee maker, I needed a way to set the used coffee filter down without tipping it over and spilling hot grounds all over the place.
So I designed this.
Even after one print I redesigned it from the ground up and I am so happy with the new design.
It prints in 4 parts. The base and ring measure in at 140mm. I also put in the file with and without the caffeine molecule so if you wanted to remix and add your own logo you could.
All parts should snap together no glue needed (at least with my prints).
** also I dont know how to put the legs on the print floor from the model so you may have to re-orient the legs to the print bed. Make sure the chamfer side is up.
** also all the legs are the same. You can grab one and duplicate or bring all 3 to your slicer.
Print times:
Ring and legs = 1hr 7 mins
Base w/ Molecule = 2 hr 47 mins
Base w/o Molecule = 1 hr 50 mins
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
