Thingiverse
Bolt Action Order Dice
von dapoppa
87
Downloads
38
Likes
0
Makes
Built these from scratch - made them 19mm in size, bigger than standard dice so the indents show up properly.
After they printed, filled the indents with crayon (old gamer trick) and rubbed against terry cloth to remove the excess. If that doesn't give great results, you can try painting the indent with paint, then use a good sandpaper to get rid of the overpaint.
Also printed on glass to get a nice smooth base finish.
I would suggest rotating the image to put the RUN side down to put the smallest word on glass.
After they printed, filled the indents with crayon (old gamer trick) and rubbed against terry cloth to remove the excess. If that doesn't give great results, you can try painting the indent with paint, then use a good sandpaper to get rid of the overpaint.
Also printed on glass to get a nice smooth base finish.
I would suggest rotating the image to put the RUN side down to put the smallest word on glass.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!