Thingiverse
boltrc gopro mount
by _elias1
3
Downloads
6
Likes
0
Makes
mount for gopro camera or something similar (yi cam, sj4000 etc).
print in 80% infill
screws go through front holes into standoffs. screws go through rear holes through the main plate, and nylon nuts to secure it on.
30 is v5,l 40 degree is v4. both are very uch the same for the exception of the angle. 20 degree is still v1 or v2 i believe so may not be as strong.
print in 80% infill
screws go through front holes into standoffs. screws go through rear holes through the main plate, and nylon nuts to secure it on.
30 is v5,l 40 degree is v4. both are very uch the same for the exception of the angle. 20 degree is still v1 or v2 i believe so may not be as strong.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!