Thingiverse
Book Box
door gustavorezende
80
Downloads
94
Likes
0
Makes
This is a little box I made. No supports required.
You will need a 1mm diameter rod, with 65.5mm in length. I used a paper clip, unfolded.
Use CA glue to join the parts and secure the rod in place ( don't glue the hinge :) )
Apply glue to the part in contact with the spine, to ensure the stiffness of the box.
If the lid doesn't fit SLIGHTLY sand the lock sideways with a fine sandpaper or nail file.
I think it would be better if printed with ABS.
Update 1/31/2021
I added 2 new versions of the covers, with some details. Not printed, yet.
You will need a 1mm diameter rod, with 65.5mm in length. I used a paper clip, unfolded.
Use CA glue to join the parts and secure the rod in place ( don't glue the hinge :) )
Apply glue to the part in contact with the spine, to ensure the stiffness of the box.
If the lid doesn't fit SLIGHTLY sand the lock sideways with a fine sandpaper or nail file.
I think it would be better if printed with ABS.
Update 1/31/2021
I added 2 new versions of the covers, with some details. Not printed, yet.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
