Thingiverse
Book stand
von nyptus
15
Downloads
20
Likes
0
Makes
During my school years, I had a disassemble book stand.
It was a handy thing: it was lightweight, took up little space and besides, there was a ruler on one half and a protractor on the other.
I reproduced the stand in a simplified form (without a ruler and protractor).
Added a couple of ribs for greater rigidity when assembled.
Material: PET-G
Layer height: 0.3 mm
Additions: Surface ironing (50%)
Infill: 80 %
Supports: NO
Temp., nozzle: 235 C
Temp., bed: 70 C
Cooling: 50 %
Speed: 135 mm/s
It was a handy thing: it was lightweight, took up little space and besides, there was a ruler on one half and a protractor on the other.
I reproduced the stand in a simplified form (without a ruler and protractor).
Added a couple of ribs for greater rigidity when assembled.
Material: PET-G
Layer height: 0.3 mm
Additions: Surface ironing (50%)
Infill: 80 %
Supports: NO
Temp., nozzle: 235 C
Temp., bed: 70 C
Cooling: 50 %
Speed: 135 mm/s
nyptus veröffentlicht auch auf
10 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
