MakerWorld
Decor
Voir le modèle
Book Wall Mount
13
Téléchargements
4
Likes
4
Makes
Hey,recently I made this small mount for a book that I got. It is pretty simple to print and uses 1 or 2 small nails (1 should be enough | Flathead nails recommended) to stay on the Wall. The design is made for a book which is approximately 24mm thick. However thinner books should work without any problems. I hope you enjoy this small model :) I used the following settings to print these 3 mounts:Material: PLALayer height: 0.15Infill: 60%Nozzle: 0.4Support: YesI recommend to rotate the model so that the long side lays flat on the bed.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !