Bookmark, Giraffe

This 3Mf was done on a Cool Plate. If you are using a different plate, make sure you change to the plate you're using. You do not need an AMS to change colours. At the layer where you should change colour, change to pause and manually change the colour when the print pauses. Bookmarks need a clean plate to avoid any corners rising. Project: Giraffe 3.hfpPrint at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 43.56x152.46mm in sizeYou may print at higher layer heights below the Min Depth of 0.64mmThe Max Depth is 1.3mm and the Actual Depth is 1.4mm Filaments Used: PLA generic Black PLA R3D Red PLA BambuLab Basic Orange PLA Polylite WhiteThis print uses 4 unique filaments Swap Instructions: Start with Black At layer #8 (0.72mm) swap to Red At layer #9 (0.8mm) swap to Orange At layer #10 (0.88mm) swap to White for the rest. Boost Me