Thingiverse
Bookshelf Bookmarks
von bamingodesign
30
Downloads
88
Likes
0
Makes
- A miniature bookshelf to mark your place in every story.
- Two manual swaps — no AMS or MMU required.
- Print Settings:
- Layer height: 0.08 mm with a base layer of 0.16 mm
- Infill: 100%
- Color Changes:
- Start with Black (Esun PLA Black)
- At layer 7 (0.64 mm), swap to Gray (Esun PLA Gray)
- You can experiment by replacing it with other colors for a vibrant look.
- At layer 10 (0.88 mm), swap to White (Esun PLA Matte Milky White)
- Notes:
- A 3MF print profile is included for easy setup
- Do not simplify the model (ignore floating regions warning)
- Scale only in X and Y
- Split objects manually by right-click menu
- Use a lighter or a heat gun to remove stringing
- Want to sell prints? Check our profile for a commercial license.
- Two manual swaps — no AMS or MMU required.
- Print Settings:
- Layer height: 0.08 mm with a base layer of 0.16 mm
- Infill: 100%
- Color Changes:
- Start with Black (Esun PLA Black)
- At layer 7 (0.64 mm), swap to Gray (Esun PLA Gray)
- You can experiment by replacing it with other colors for a vibrant look.
- At layer 10 (0.88 mm), swap to White (Esun PLA Matte Milky White)
- Notes:
- A 3MF print profile is included for easy setup
- Do not simplify the model (ignore floating regions warning)
- Scale only in X and Y
- Split objects manually by right-click menu
- Use a lighter or a heat gun to remove stringing
- Want to sell prints? Check our profile for a commercial license.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
