MakerWorld
Decor
Ver Modelo
Boost Base Rocket League - with LED lamp version
406
Descargas
350
Likes
117
Makes
🚨ATTENTION 🚨You can use ANY car you want to use this boost base.I used the Fennec by C23_Dixon but I made a change on back light from the original file to snap the magnets on it🚨🚨🚨 VERY IMPORTANT - The car should be light, otherwise the magnets will not hold the weight.When I printed the Fennec ☝️I didn't pay attention to that detail, so the car was 173g (without wheels) and this was very heavy for the magnets.So I had to do a workaround because I didn't want to reprint the carI dug a hole in the car to try to reduce its total mass as much as possible, the car now is 143g (with wheels) and I covered the hole with a piece of PLA (0.4mm height about ~2 layers) - the ideal weight would be below 120g for only 4 magnets (2 on car and 2 on boost base)but in my case the car still over the ideal weight, so I used 6 m
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
